CRM Mitchell1 2023-10-02T22:00:45+00:002007 Honda Accord CRM Mitchell1 2023-10-02T22:00:45+00:00
- Found initially both vents would blow cold. after letting vehicle run in the shop for a 15 minutes passenger side would eventually go hot. At this time, there is a difference in air flow from the drivers side and passenger side. When drivers side is controlled to hot found an even amount of air flow from drivers side and passenger side. This is considered normal when controls are set to hot. There is not an HVAC control module available to scan and monitor data however a code B1236 (passenger side air mix control circuit open) is present in multiple modules. Gained access to passenger side air mix actuator and once I gained access the actuator would not act up. Began wiggling wires to actuator and it would continue to operate. Check connection to actuator and it looks ok. Most likely the passenger side air mix actuator is failing and goes to full hot mode as a default.
- HVAC BLEND DOOR ACTUATOR – Remove & Replace – Passenger Side
Judy O. gave our service a 5 star review on 10/1/2023